Hi Guys,
I have a strange problem on a report where when the report runs the very first time from opening excel it is fine, thereafter if you try and change the company the report gets stuck at a certain cell.
I have obviously checked that cell and there is nothing peculiar there and have even deleted the reference only to see that the report will still get stuck at the next formula. Either way, the report does work as it always runs perfectly the very first time.
The only way I can get it to run a second or consecutive time is to cancel it while it is stuck, take it back to designer and it still also gets stuck here, so i have to cancel again and then i can change the company and run the report.
To me it seems as if it is not clearing some data somewhere in between changing the filter options?
Any suggestions?
I am using excel 2003 and Jet Version 7.1.2 1830
Date
Votes
3 comments
-
Jet Reports Historic Posts Does it only happen when you change company? i.e. can you switch between design and report modes if you do not change the company?
-
Jet Reports Historic Posts Hi Mark,
No it gets stuck even going into design mode and i have to cancel the jet progress window to get back to the report. -
Jet Reports Historic Posts When you hit the 'show details' button on the jet calculation screen, does it give you any information about the current cell, key, etc or is there no info at all?
Secondly, if you open the report, then just hit 'report' again, does it run?
Please sign in to leave a comment.