0

Jet Reports 20.3 auto-calculates on manual formula mode

I recently upgraded from Jet reports v 18.1 to 20.3. Previously I was able to leave my reports in design mode and as long as I had manual calculation on, they did not refresh upon reopening the workbook. This seems to have changed in 20.3 as I have manual calculation on and Jet reports still runs in design mode upon opening. If I cancel the run, it errors out the whole workbook.

I do not want to constantly move the report between design and report mode as it takes 2+ hours to move between the two modes and calculate and I don't have time for that, so I have been leaving it in design mode with manual calc as a workaround. Has anyone else had an issue like this? Is there a way to stop autocalc in design mode in 20.3? 

1 comment

Please sign in to leave a comment.